OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0391

Camshaft Position Sensor B Circuit Range/Performance Bank 2

Camshaft position sensor B is the exhaust camshaft sensor; bank 2 is the side without cylinder 1, so the code only occurs on V and boxer engines with one exhaust cam sensor per bank. P0391 means the bank 2 exhaust cam signal is present, but the number or position of its pulses does not fit the crankshaft. GM's 3.0 twin-turbo V6 (LGW) expects 4 to 6 pulses in the first 12 reference events and 398 to 402 per 100 engine cycles on the four-tooth wheel, after two trips; the Saab 9-4X 2.8 turbo V6 (LAU) checks pulses per crank revolution below 2,520 rpm. The 2004 Northstar requires each edge within a window of crank teeth, and GM's 2004 3.6-litre V6 (LY7) counts implausible signals over two drive cycles. The phaser then goes to its base position and the engine cranks longer. Mechanical causes – damaged tone wheel, jumped chain – matter more here than with P0390.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 91

Possible causes

  • Tone wheel on the bank 2 exhaust phaser damaged, loose or wrongly fitted high
  • Interference or loose contact producing extra edges medium
  • Sensor loose, wrong O-ring or gap, chips on the magnet medium
  • Timing chain stretched or jumped medium
  • Sensor faulty medium

Symptoms

  • Check engine light on
  • Loss of power (bank 2 exhaust cam timing in its base position)
  • Longer cranking
  • Rough idle
  • Occasional stalling

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0391

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 6 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication