OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0390

Camshaft Position Sensor B Circuit Bank 2

Camshaft position sensor B is the exhaust camshaft sensor; bank 2 is the side without cylinder 1, so the code only occurs on V and boxer engines with one exhaust cam sensor per bank. P0390 means no or too few exhaust cam pulses arrive from bank 2 while the crankshaft turns. GM's 3.0 twin-turbo V6 (LGW) sets it after 5.5 s without a cam pulse, 4 s of cranking or fewer than 4 pulses in 3 s, after two trips; for GM it collects all circuit faults. GM's 3.6-litre V6 in the Saab 9-4X also counts 800 of 1,000 engine cycles without a pulse. Ford checks the crank-to-cam ratio from 200 rpm within 5 s, and the 2004 Northstar counts missing signal changes up to 16. The bank 2 exhaust phaser then locks in its base position; the engine keeps running on the crank and intake cam sensors. FCA advises saving the synchronisation data before replacing the sensor.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 90

Possible causes

  • Connector or wiring of the bank 2 exhaust sensor open or corroded (signal, 5 V, ground) high
  • Camshaft position sensor faulty high
  • Oil contamination or leak at the sensor, sensor loose medium
  • Tone wheel on the phaser damaged or wrongly fitted after timing chain work medium
  • Engine module, or 5 V reference shorted by another sensor low

Symptoms

  • Check engine light on
  • Loss of power (bank 2 exhaust cam timing in its base position)
  • Longer cranking
  • Rough idle
  • Higher fuel consumption

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0390

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 5 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication