P038E
Ignition J Control Signal Circuit Low
Ignition J is one of the control signal lines from the engine module to an ignition module, ignition output stage or group of coils; which cylinders it serves is defined by the manufacturer, not by the code standard. The code concerns the logic-level control signal, not the coil's primary current (that has its own codes, P0351 ff and P2300 ff). P038E means the control line reads low – typically shorted to ground. No manufacturer using these codes was found – neither GM nor Ford use the Ignition A to J codes; GM reports coil control faults as P0351 ff – so the description follows CARB and that analogy. The affected coils fire wrongly or not at all, causing misfire; many modules then shut off injection to those cylinders to protect the catalyst.
Possible causes
- Control line shorted to ground (chafing) high
- Input of the ignition module or coil shorted medium
- Moisture or corrosion in the connector medium
- Driver stage in the engine module low
Symptoms
- Check engine light on
- Misfire, jerking, rough idle
- Loss of power, possibly cylinders shut off
- Additional misfire codes P0300 ff
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P038E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.