OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0389

Crankshaft Position Sensor B Circuit Intermittent

Some engines have a second crankshaft sensor or a second track on the tone wheel – GM's 3.4/3.5/3.8-litre V6 use the low resolution track of a dual Hall sensor, the Honda 3.5-litre in the Saturn Vue Redline a second sensor – which the engine module checks against sensor A or the camshaft. By its J2012 name P0389 means the signal of sensor B drops out for moments or becomes erratic – missing or extra edges – without staying permanently low or high. Such faults are typically found by counting pulses against sensor A or the camshaft, as GM's 3.8-litre V6 and the Honda engine do; both, however, report the result under P0385/P0386, and no manufacturer document available to us uses P0389. The description therefore follows the J2012 name, these component sources and CARB. Typical causes are a loose contact, a broken wire and interference.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 89

Possible causes

  • Loose contact or corrosion at the sensor B connector high
  • Wire break or chafing that appears with engine movement high
  • Electrical interference (add-on devices, routing near ignition or relays) medium
  • Tone wheel damaged or dirty, air gap too large medium
  • Sensor faulty, temperature-dependent medium

Symptoms

  • Check engine light on, possibly only after several trips
  • Occasional stalling or jerking
  • Sporadic starting problems

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0389

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication