OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0388

Crankshaft Position Sensor B Circuit High

Some engines have a second crankshaft sensor or a second track on the tone wheel – GM's 3.4/3.5/3.8-litre V6 use the low resolution track of a dual Hall sensor, the Honda 3.5-litre in the Saturn Vue Redline a second sensor – which the engine module checks against sensor A or the camshaft. By its J2012 name P0388 means the signal of sensor B stays above its upper limit – with a Hall sensor typically an open signal wire held high by the module's pull-up, or a short to positive. No manufacturer document available to us uses P0388: the engines with a sensor B report its electrical faults under P0385 and implausible signals under P0386. The description therefore follows the J2012 name, these component sources and CARB's monitoring requirement for crank angle sensors. The engine usually keeps running on sensor A; longer cranking is possible.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 88

Possible causes

  • Signal wire of sensor B open or connector corroded or loose high
  • Signal wire shorted to positive or reference voltage medium
  • Sensor ground open medium
  • Sensor B faulty internally medium
  • Engine module input low

Symptoms

  • Check engine light on
  • Longer cranking or starting problems
  • Possibly rough running or misfire
  • Often no noticeable symptoms while sensor A takes over

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0388

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication