OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0384

Glow Plug Control Module 1 Control Circuit High

P0384 is the counterpart of P0383: the control line from the engine module to the glow plug control module is too high, i.e. shorted to positive. In GM's logic for the 2010/11 Saab 9-5 2.0 TiD the signal terminal should show 9.5–10.5 V; a higher voltage for more than 0.5 s, with ignition on and 9–16 V, sets the code, there without check engine light. Ford's 2023 diesels (6.7 and 3.0 litre) use P0384 differently from the J2012 name, for the supply voltage of the glow plug module: below 6.5 V, above 16.5 V or open, detected in about 1 s – today J2012 has P052F for that. So with Ford, check battery, alternator and the module's supply first. The consequence is missing or irregular preheating or a protective shutdown of the module, with a poor cold start.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 84

Possible causes

  • Control line chafed against positive or bridged in the connector high
  • Glow plug control module faulty internally (feeding back) medium
  • Ford: supply of the module outside 6.5–16.5 V or open (battery, alternator, fuse) medium
  • Engine module low

Symptoms

  • No or irregular preheating, hard starting when cold
  • Smoke after a cold start
  • Warning lamp depending on the manufacturer

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0384

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication