OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0383

Glow Plug Control Module 1 Control Circuit Low

Many diesels have a separate glow plug control module that the engine module commands over a control line. P0383 means this line is too low. In GM's logic for the 2010/11 Saab 9-5 2.0 TiD the engine module drives the module with a PWM signal and holds about 10 V on the line at rest (9.5–10.5 V at the signal terminal); if it reads too little voltage for more than 0.5 s – short to ground, or an open circuit or high resistance – it sets P0383, with ignition on, 9–16 V, once per ignition cycle. In that European version the code does not turn on the check engine light. Without a valid command the module does not glow, so the engine starts poorly when cold. Ford uses P0384 differently and not P0383; GM's 2016/2018 diesels have their output stages in the engine module and no such line. For US vehicles there is no code-specific source.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 83

Possible causes

  • Control line between engine module and glow plug module shorted to ground or open high
  • Corroded connector at the glow plug module in the engine bay medium
  • Glow plug control module faulty (input pulls the line down) medium
  • Driver in the engine module low

Symptoms

  • No preheating, poor cold start
  • Smoke after a cold start
  • Warning lamp depending on the manufacturer

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0383

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication