OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0382

Glow Plug/Heater Circuit B

P0382 is the counterpart of P0380 for glow plug circuit B – depending on the manufacturer the second group of plugs, glow relay 2 or feedback line B of the glow plug control module. A code-specific manufacturer description exists from Saab: the 3.0 TiD V6 diesel in the 9-5 (2002) reads two feedback lines from its glow plug control module, and if line B stays above 4.0 V for more than 3 s while glowing, the module is reporting a fault in the second group of plugs; the check runs once per drive cycle, the warning lamp comes on and there is no further system reaction. Newer GM and Ford diesels report single plugs under P0671 ff and do not use P0382. CARB requires glow plug circuits to be monitored for correct current and voltage drop. The typical consequence is a poor cold start with smoke.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 82

Possible causes

  • Glow plug(s) in circuit B burnt out high
  • Glow plug control module or glow relay 2 faulty medium
  • Feedback line B, plug connector or busbar faulty medium

Symptoms

  • Hard starting when cold, long cranking
  • White or blue smoke and rough running after a cold start
  • Glow plug light or check engine light on or flashing

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0382

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication