P037E
Glow Plug Sense Circuit Low
P037E means the voltage read back from the glow plug supply is too low. GM's 2016/2018 diesels, whose glow plug output stages sit in the engine module, compare the feedback with the battery voltage while glowing: if it is lower by more than a calibrated, current-dependent threshold – excessive voltage drop or a short to ground of the sense line – a sample counts as faulty, and 60 of 120 samples in a 50 ms grid set the code, roughly 3 of 6 s. The check only runs with the engine running (afterglow), not while cranking, and is suspended if a single plug or the supply already has an electrical fault. GM classes the cause as internal to the module (measuring circuit) and turns on the check engine light after two trips. There is no limp mode; glow plug monitoring is restricted.
Possible causes
- High contact resistance in the glow plug supply (connector, ground, fusible link) high
- Measuring circuit or output stage in the engine module medium
- Sense or supply wire shorted to ground medium
- Weak battery or vehicle voltage at the edge of the enable range low
Symptoms
- Check engine light on
- Possibly hard starting or knocking when cold
- Further glow plug codes
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P037E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.