P037D
Glow Plug Sense Circuit
To check the glow plugs, the engine module reads back the voltage or current of the glow plug supply through a sense circuit – CARB requires glow plug circuits to be monitored for correct current and voltage drop, and from model year 2010 the failure of a single plug to be detected. In the J2012 scheme P037D is the general code for this sense circuit, P037E and P037F its low and high counterparts. None of the manufacturer documents available to us uses P037D: GM's 2016/2018 diesels use only P037E/P037F, Ford 2023 its own glow plug codes (P0671 ff, P064C) and Saab reports the feedback of its glow plug control module as P0380/P0382. The description therefore follows CARB and the GM sister codes. Typically glow plug monitoring is inactive; glowing itself can work normally.
Possible causes
- Sense wire open or high resistance, connector corroded high
- Glow relay or glow plug control module giving an implausible feedback medium
- Fuse or fusible link of the glow plug supply blown medium
- Engine module internal low
Symptoms
- Check engine light or glow plug light on
- Possibly poor cold start if the cause also affects the glow plug supply
- Further glow plug codes stored
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P037D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.