OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P037A

Glow Plug/Heater Indicator Control Circuit Low

Diesel engines show the driver a wait-to-start lamp while the glow plugs preheat; the engine module switches it with a high-side driver. P037A means the lamp control circuit is too low – in practice a short to ground on the line to the instrument cluster. GM's diesels detect it in the driver itself: about 0.5 Ω to ground with the lamp commanded, only with a lamp configured, ignition on, more than 11 V and not while cranking. The 2015 engines need 3 s of fault, the 2016/2018 engines 10 of 15 samples; the check engine light follows after two trips. The glow plugs keep working; only the indication is missing, so the driver may start too early. CARB requires monitoring of the wait-to-start lamp circuit. Ford reports lamp faults under P0381 and does not use P037A.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 7A

Possible causes

  • Lamp control wire chafed through to ground between engine module and cluster high
  • Lamp or LED driver in the instrument cluster shorted internally medium
  • Moisture or corrosion in the module or cluster connector medium
  • Driver in the engine module faulty low

Symptoms

  • Glow plug light does not come on or stays dim
  • Check engine light on (GM after two trips)
  • Driver starts too early, possibly poor cold start

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P037A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication