P0370
Timing Reference High Resolution Signal A
Some diesel systems give the injection control a finely divided angle signal in addition to the normal reference signal, to time and meter injection precisely – the high resolution signal. GM's 6.5-litre diesel (1997) had an optical sensor in the injection pump that delivers a high resolution track and one cam reference pulse per cylinder; P0370 is set if more than 8 consecutive cam pulses pass without progress on the high resolution counter, in the first trip. The engine then runs on backup fuelling with reduced power, and injection timing control is suspended. On the 2004 Duramax LB7 the injector driver module evaluates the 57X crank signal and reports 'no crank signal' over CAN; from 60 rpm, 100 of 120 samples sets P0370, also in the first trip. Petrol engines practically do not use the code.
Possible causes
- Optical sensor in the injection pump faulty (6.5-litre) high
- Wiring or connector between pump or sensor and module medium
- Crankshaft sensor or tone wheel (LB7: 57X signal) medium
- Injector driver module, engine module or CAN communication low
Symptoms
- Check engine light on
- Loss of power (limp-home fuelling)
- Rough running, hard starting, smoke
- Stalling possible
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0370
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 5 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.