OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0369

Camshaft Position Sensor B Circuit Intermittent Bank 1

Camshaft position sensor B is the exhaust camshaft sensor (bank 1 = side with cylinder 1), usually a Hall sensor on the exhaust cam phaser. P0369 means its signal is basically present, but now and then a cam pulse arrives at a crank angle where none is expected, or pulses drop out. Ford checks this in its camshaft ignition system test from 200 rpm and decides within 5 s; with this and the other cam timing codes active, Ford also suspends its oxygen sensor monitor. FCA lists P0369 among the cam sensor codes for which the cam/crank synchronisation event data should be read before replacing the sensor. GM does not use the code (2014–2019 only P0365/P0366). Typical causes are a loose contact, interference from ignition wiring and a sensor with metal debris or a borderline air gap.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 69

Possible causes

  • Loose contact in connector or wiring high
  • Interference from the ignition (routing, shielding) medium
  • Sensor with metal debris or borderline air gap medium
  • Tone wheel or phaser damaged low

Symptoms

  • Check engine light on
  • Sporadic jerking or stalling
  • Occasional starting problems

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0369

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication