OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0367

Camshaft Position Sensor B Circuit Low Bank 1

Camshaft position sensor B is the exhaust camshaft sensor (bank 1 = side with cylinder 1), usually a Hall sensor on the exhaust cam phaser. The engine module holds the signal line at about 5 V and the sensor pulls it to ground with each tooth. P0367 means the line stays low without edges – typically a short to ground of the signal wire or a sensor shorted internally. A code-specific manufacturer description exists only from GM: on the Saab 9-4X 2.8 turbo V6 (LAU) the signal must stay low without pulses for more than 1 s, or 10 s cumulatively, after more than 10 crank revolutions and below 2,520 rpm, and the code follows after two trips; with the sensor disconnected the signal wire should show 4.8–5.2 V. GM's other engines of 2014–2019 and Ford report such faults under P0365. The consequence is as for P0365: exhaust cam timing in its base position, longer cranking.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 67

Possible causes

  • Signal wire chafed through to ground high
  • Sensor shorted internally medium
  • Oil or water in the connector medium
  • Engine module low

Symptoms

  • Check engine light on
  • Longer cranking before the engine starts
  • Loss of power or rough idle (exhaust cam timing in its base position)

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0367

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication