OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0366

Camshaft Position Sensor B Circuit Range/Performance Bank 1

Camshaft position sensor B is the exhaust camshaft sensor (bank 1 = side with cylinder 1), usually a Hall sensor on the exhaust cam phaser. P0366 means its pulses arrive, but their number or position does not fit the crankshaft. GM expects 400 pulses per 100 engine cycles and sets the code outside 398–402, or with fewer than 4 or more than 6 pulses in the first 12 reference events at start, 8 of 10 samples, after two trips. On GM's 3.6-litre V6 in the Saab 9-4X the exhaust phaser then goes to its park position and ignition runs from the crankshaft alone; on the 2.8 turbo V6 (LAU) the fault must last 1 s, or 10 s cumulatively, below 2,520 rpm. Saab's workshop information names a damaged tone wheel, play, foreign matter and too large an air gap. Ford uses the code too but publishes no thresholds.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 66

Possible causes

  • Sensor faulty or dirty (metal debris on the magnet) high
  • Wiring close to ignition coils or solenoids, loose contact medium
  • Tone wheel on the phaser damaged or loose, air gap too large medium
  • Sensor or phaser wrongly fitted after timing drive work low

Symptoms

  • Check engine light on
  • Longer cranking before the engine starts
  • Loss of power or rough idle (exhaust cam timing in its base position)
  • Higher fuel consumption

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0366

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 5 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication