OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0365

Camshaft Position Sensor B Circuit Bank 1

Camshaft position sensor B is the exhaust camshaft sensor (bank 1 = side with cylinder 1), usually a Hall sensor on the exhaust cam phaser. P0365 means no or too few exhaust cam pulses arrive while the crankshaft turns in sync. GM sets it after 4 s of cranking or 5.5 s without a cam pulse, or fewer than 4 pulses in 3 s running, 8 of 10 samples, after two trips; on GM's 3.6-litre V6 (Saab 9-4X) also with no pulse in 800 of 1,000 engine cycles. Ford checks the ratio of crank to cam events from 200 rpm, detected within 5 s, and collects all electrical faults here. The exhaust phaser then goes to its park position; the engine keeps running but cranks longer and loses some power. FCA advises saving the cam/crank synchronisation data before replacing the sensor, as the fault is often elsewhere.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 65

Possible causes

  • Exhaust camshaft position sensor faulty high
  • Connector or wiring open or corroded, 5 V reference missing high
  • Oil in the connector from a leaking sensor O-ring medium
  • Tone wheel on the exhaust phaser damaged or loose low
  • Engine module (5 V supply) low

Symptoms

  • Check engine light on
  • Longer cranking before the engine starts
  • Loss of power or rough idle (exhaust cam timing in its base position)
  • Higher fuel consumption

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0365

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication