OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0362

Ignition Coil L Primary Control Circuit/Open

P0362 monitors the primary control circuit of ignition coil L – the line from the engine module to the coil or to its built-in output stage – for an open circuit or high resistance. Coil L usually serves cylinder 12, so the code only occurs on engines with at least 12 cylinders; in practice these are V12 or W12 engines. No manufacturer document available to us uses the code: GM goes up to coil H, Ford's descriptions end at coil J (P0360). CARB requires the ignition outputs to be monitored for open and short circuits. Ford's description of the same check for coils A to J shows how it works: it runs continuously between 200 and about 3,200 rpm at 11–16 V, judges either the current confirmation from the coil driver or the current and voltage at the driver output, and after a coil fault shuts off that cylinder's injector for 30 s at a time to protect the catalyst. Coil L's control circuit low and high are P2333 and P2334, its secondary circuit P2335.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 62

Possible causes

  • Ignition coil L faulty (output stage in the coil or primary winding open) high
  • Connector at the coil corroded, wet or with a loose pin high
  • Control, supply or ground wire open or chafed medium
  • Driver in the engine module faulty or software (permanent dwell) low

Symptoms

  • Check engine light on
  • Misfire and rough running on cylinder 12, often also P0312
  • Loss of power, jerking under load
  • Cylinder shut off (injection off), risk to the catalyst if driven on

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0362

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication