OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0356

Ignition Coil F Primary Control Circuit/Open

P0356 monitors the primary control circuit of ignition coil F – the line from the engine module to the coil or to its built-in output stage – for an open circuit or high resistance. Coil F usually serves cylinder 6, so the code only occurs on engines with at least 6 cylinders. GM's 6.2-litre V8s (LT4, LT5) flag an open circuit above 30 kΩ with the driver off in 50 of 63 samples, after two trips. Ford checks continuously from 200 rpm within 1 s, expecting a primary-current feedback for every ignition command, and then shuts off injection to that cylinder for 30 s at a time to protect the catalyst. GM bulletin PIP5038B describes coils on the 3.6-litre V6 (LLT) overheating from a permanently switched-on control signal; PIP5147 advises checking coil connectors for water. Short circuits have their own codes (P2315 ff).

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 56

Possible causes

  • Ignition coil F faulty (output stage in the coil or primary winding open) high
  • Connector at the coil corroded, wet or with a loose pin high
  • Control, supply or ground wire open or chafed medium
  • Driver in the engine module faulty or software (permanent dwell) low

Symptoms

  • Check engine light on
  • Misfire and rough running on cylinder 6, often also P0306
  • Loss of power, jerking under load
  • Cylinder shut off (injection off), risk to the catalyst if driven on

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0356

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication