OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0353

Ignition Coil C Primary Control Circuit/Open

Modern engines have one coil-on-plug ignition coil per cylinder, with the output stage either in the engine module or in the coil itself. P0353 monitors the primary control circuit of coil C – the line from the engine module to the coil or its built-in output stage – for an open circuit or high resistance. GM's module measures the voltage with its low-side driver off and flags an open circuit above 30 kΩ in 50 of 63 samples (2018 engines in the first trip, older ones after two); Ford checks continuously within 1 s, expecting a primary-current feedback for every ignition command, and shuts off injection to that cylinder for 30 s at a time. Short circuits and the secondary side have their own codes (P2300 ff). Coil C usually serves cylinder 3, but the assignment is up to the manufacturer.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 53

Possible causes

  • Ignition coil C faulty (output stage in the coil or primary winding open) high
  • Connector at the coil corroded, loose or with a spread pin high
  • Control, supply or ground wire open or chafed medium
  • Fuse or relay of the coil supply (then usually several codes) low
  • Driver in the engine module faulty low

Symptoms

  • Check engine light on
  • Misfire and rough running on cylinder 3, often also P0303
  • Loss of power, jerking under load
  • Cylinder shut off (injection off), risk to the catalyst if driven on

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0353

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication