OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P034B

Crankshaft Position Sensor - Crankshaft Direction Incorrect

Direction-sensing (bidirectional) crank sensors count the rest position for start-stop even when the crankshaft rocks back after shut-off. In normal running the sensor must never report reverse rotation – if it does, the signal is disturbed. GM sets P034B after at least 3 direction reversals within 10 s at 400 to 2,000 rpm and an airflow of at least 1.5 g/s, after two trips; the diesel uses the same thresholds. GM bulletin 17-NA-317 describes the 3.6 V6 (LFY) in the 2018 Buick Enclave and Chevrolet Traverse: interference in the sensor circuit caused P034B with P0506, low idle or stalling after an autostart, transmission slip above 65 km/h and cruise control dropping out; the remedy was a revised sensor wiring. Result: start-stop disabled, possibly reduced power.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 4B

Possible causes

  • Interference in the sensor circuit (wiring routed next to switching lines) high
  • Direction-sensing crankshaft position sensor faulty medium
  • Ground or connector fault medium
  • Tone wheel or air gap low

Symptoms

  • Check engine light on
  • Low idle or stalling after an autostart
  • Start-stop off, possibly reduced power
  • Follow-on effects such as transmission slip or cruise control dropping out (GM LFY)

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P034B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication