OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0349

Camshaft Position Sensor A Circuit Intermittent Bank 2

P0349 is the bank 2 counterpart of P0344: the signal of the intake camshaft sensor on the side without cylinder 1 is disturbed for moments – edges are missing or appear at an unexpected angle. Ford checks this on the five-tooth wheel used with variable cam timing; if edges appear where none are expected, Ford sets P0349 and switches cam timing on bank 2 off, from 200 rpm, detected within 5 s. FCA also uses the code and asks for the cam/crank synchronisation event data to be saved before the sensor is replaced, because a disturbed crank reference can look like a cam fault. GM does not use P0349. Typical causes are a loose contact at the bank 2 connector, a sensor dropping out when hot or soaked with oil moisture, and a damaged tone wheel.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 49

Possible causes

  • Loose contact or corrosion at the bank 2 connector high
  • Sensor dropping out when hot or due to oil moisture medium
  • Tone wheel of bank 2 damaged medium
  • Interference or chafed wiring low

Symptoms

  • Check engine light on
  • Sporadic loss of power (cam timing off)
  • Rough running
  • Occasionally longer cranking

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0349

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 5 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication