OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0348

Camshaft Position Sensor A Circuit High Bank 2

P0348 is the bank 2 counterpart of P0343: the signal of the intake camshaft sensor on the side without cylinder 1 stays at supply level without edges. Causes are a signal wire shorted to positive, an open signal wire held high by the module's pull-up, a broken sensor ground or a faulty sensor. A code-specific manufacturer description exists only from GM: on the Saab 9-4X V6 (GM LAU) the signal must stay high without pulses for more than 1 s, or 10 s cumulatively, and the code follows after two trips. Ford's 2023 diesel shows the same check on bank 1 (P0343: system voltage over 10 or more crank revolutions). Other GM engines and Ford petrol engines report such faults under P0345. Result: cam timing on bank 2 switched off, loss of power.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 48

Possible causes

  • Bank 2 signal wire open or shorted to positive high
  • Sensor ground open medium
  • Camshaft position sensor bank 2 faulty medium
  • Connector corroded medium

Symptoms

  • Check engine light on
  • Longer cranking before the engine starts
  • Loss of power (cam timing held in its base position)
  • Rough idle, occasionally stalling

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0348

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication