OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0347

Camshaft Position Sensor A Circuit Low Bank 2

P0347 is the bank 2 counterpart of P0342: the signal of the intake camshaft sensor on the side without cylinder 1 stays at ground level without edges – signal wire shorted to ground, sensor supply missing or the sensor faulty. A code-specific manufacturer description exists only from GM: on the Saab 9-4X V6 (GM LAU) the signal must stay low without pulses for more than 1 s, or 10 s cumulatively, and the code follows after two trips. GM's other engines of 2014–2019 and Ford report such faults under P0345. Saab's 3.0 TiD diesel (2002) uses P0347 differently for a missing cam signal over 24 crank revolutions from 600 rpm. Result: cam timing on bank 2 switched off, loss of power, possibly longer cranking.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 47

Possible causes

  • Bank 2 signal wire shorted to ground high
  • Sensor supply missing medium
  • Camshaft position sensor bank 2 faulty medium
  • Connector or wiring damaged medium

Symptoms

  • Check engine light on
  • Longer cranking before the engine starts
  • Loss of power (cam timing held in its base position)
  • Rough idle, occasionally stalling

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0347

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication