OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0346

Camshaft Position Sensor A Circuit Range/Performance Bank 2

P0346 is the bank 2 counterpart of P0341: the intake camshaft sensor on the side without cylinder 1 delivers pulses, but their number or pattern does not fit the crankshaft. GM applies the same counting criteria as for P0341, e.g. on the 3.0 twin-turbo V6 (LGW): 4 to 6 pulses in the first 12 reference events and 398 to 402 per 100 engine cycles on the 4X wheel, set after two trips. On the Saab 9-4X V6 (GM LAU) the code means too many or too few pulses per crank revolution, or no correlation with crank position, for more than 1 s or 10 s cumulatively, also after two trips. Ford petrol engines do not use the code and report such faults under P0349. Result: cam timing on bank 2 switched off, loss of power, rough running.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 46

Possible causes

  • Bank 2 sensor with disturbed signal, air gap high
  • Tone wheel on the bank 2 phaser damaged or wrongly fitted medium
  • Connector, wiring or interference medium
  • Crankshaft reference signal disturbed low

Symptoms

  • Check engine light on
  • Longer cranking before the engine starts
  • Loss of power (cam timing held in its base position)
  • Rough idle, occasionally stalling

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0346

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 5 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication