OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0345

Camshaft Position Sensor A Circuit Bank 2

P0345 is the bank 2 counterpart of P0340: the intake camshaft sensor on the side without cylinder 1 – only on V and boxer engines with one cam sensor per bank – delivers no or too few pulses while the crankshaft turns in sync. GM uses the same criteria as for P0340, e.g. on the 3.0 twin-turbo V6 (LGW): 5.5 s or 4 s of cranking without a cam pulse, or fewer than 4 pulses in 3 s running, set after two trips. Ford checks the ratio of cam to crank events from 200 rpm, detected within 5 s. FCA lists P0345 among the cam sensor codes for which the synchronisation event data should be saved before replacing the sensor. Result: cam timing on bank 2 is switched off and power drops; the cam phase usually remains available from the bank 1 sensor.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 45

Possible causes

  • Camshaft position sensor bank 2 faulty high
  • Connector or wiring of bank 2 corroded or open high
  • Tone wheel or phaser of bank 2 damaged medium
  • Timing drive of bank 2 jumped low

Symptoms

  • Check engine light on
  • Longer cranking before the engine starts
  • Loss of power (cam timing held in its base position)
  • Rough idle, occasionally stalling

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0345

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 5 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication