OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0344

Camshaft Position Sensor A Circuit Intermittent Bank 1 or Single Sensor

P0344 means the signal of the intake camshaft sensor of bank 1 (or the only cam sensor) is disturbed for moments: edges are missing or appear at an unexpected angle. Ford checks this on the five-tooth wheel used with variable cam timing; if edges appear where none are expected, Ford sets P0344 and switches cam timing off (loss of power and torque), from 200 rpm, detected within 5 s. In Ford hybrids (C-Max, Fusion, MKZ 2013–2020) moisture in the engine oil from short trips caused P0340 and P0344 – remedy: new sensor and oil change (SSM 48598). FCA asks for the cam/crank synchronisation event data to be saved before replacing a cam sensor. The 2010 Saab 9-5 2.0 diesel uses P0344 differently for too few cam pulses.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 44

Possible causes

  • Moisture or oil inside the sensor, dropping out when hot high
  • Loose contact or corrosion at the connector high
  • Tone wheel on the phaser damaged or loose medium
  • Interference or chafed wiring medium
  • Crankshaft signal disturbed (wrong reference) low

Symptoms

  • Check engine light on
  • Sporadic loss of power (cam timing off)
  • Jerking, rough idle
  • Occasionally longer cranking

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0344

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 5 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication