OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0343

Camshaft Position Sensor A Circuit High Bank 1 or Single Sensor

P0343 means the signal of the intake camshaft sensor of bank 1 (or the only cam sensor) stays at supply level without edges. Causes are a signal wire shorted to positive, an open signal wire that the module's pull-up holds at 5 V, a broken sensor ground or a faulty sensor. Ford's 2023 diesel sets it when the signal stays at system voltage over 10 or more crank revolutions (3 s). On the Saab 9-4X V6 (GM LAU) the signal must stay high without pulses for more than 1 s, or 10 s cumulatively, and the code follows after two trips. Saab's Motronic 2.8.1 (900 V6) treats low and high together and allows an air gap of at most 1.5 mm. The consequences are as for P0340: longer cranking, cam timing switched off, loss of power.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 43

Possible causes

  • Signal wire open or shorted to positive high
  • Sensor ground open medium
  • Camshaft position sensor faulty medium
  • Connector corroded medium

Symptoms

  • Check engine light on
  • Longer cranking before the engine starts
  • Loss of power (cam timing held in its base position)
  • Rough idle, occasionally stalling

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0343

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication