OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0342

Camshaft Position Sensor A Circuit Low Bank 1 or Single Sensor

P0342 means the signal of the intake camshaft sensor of bank 1 (or the only cam sensor) stays at ground level without edges – signal wire shorted to ground, sensor supply missing or the Hall sensor faulty. Ford's 2023 diesel sets it when the signal stays at 0 V over 10 or more crank revolutions (3 s), while cranking or running. On the Saab 9-4X V6 (GM LAU) the signal must stay low without pulses for more than 1 s, or 10 s cumulatively, and the code follows after two trips; with the sensor disconnected the signal wire should show 4.8–5.2 V. Saab's Motronic 2.8.1 (900 V6) treats low and high together: no connection or short to ground or battery, about 4.5 V at idle, air gap at most 1.5 mm. GM petrol engines 2014–2019 and Ford petrol engines report this under P0340.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 42

Possible causes

  • Signal wire shorted to ground high
  • 5 V or 12 V supply of the sensor missing medium
  • Camshaft position sensor faulty medium
  • Connector corroded or wiring chafed medium

Symptoms

  • Check engine light on
  • Longer cranking before the engine starts
  • Loss of power (cam timing held in its base position)
  • Rough idle, occasionally stalling

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0342

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication