P0338
Crankshaft Position Sensor A Circuit High
By its J2012 name P0338 means the crankshaft position signal stays at a high level – signal wire shorted to supply, or an open signal output that the module's pull-up holds high on a Hall sensor. GM 2014–2019 and Ford do not use the code. GM's Global A engines in the Saab 9-5 (2010/11) and 9-4X define it as a high duty cycle, i.e. too many pulses or teeth between the reference gaps: on the 2.8 turbo V6 (LAU) a deviation of more than 8 teeth, checked once per revolution and set in the first trip; on the 1.6 (LLU) more than 200 reference pulses in 10 revolutions, and on the 2.0 turbo (LDK) a large tooth deviation over 4 revolutions, both after two trips. Behind this are usually interference pulses or a gap that is not recognised. Result: misfire, stalling, limp mode.
Possible causes
- Signal wire shorted to supply or open (pull-up holds the level high) high
- Interference pulses from poor ground or shielding medium
- Crankshaft position sensor faulty medium
- Tone wheel damaged or dirty (gap not recognised) low
Symptoms
- Misfire, jerking
- Engine stalls or starts poorly
- Limp mode
- Check engine light on
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0338
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- saabwisonline.com/9-4x/2011/2-engine/engine-management-and-fuel-system-v6/fault-diagnosis-diagnostic-trouble-codes/dtc-p0335-p0336-or-p0338-lau
- saabwisonline.com/9-5-9650/2011/2-engine/engine-management-and-fuel-system-1-6-l-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p0335-p0338-llu
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p0335-p0336-or-p0338-ldk-with-turbocharger
- law.cornell.edu/regulations/california/13-CCR-1968.2
- hella.com/techworld/en/technical/sensors-and-actuators/crankshaft-sensor/