OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0335

Crankshaft Position Sensor A Circuit

The crankshaft position sensor reads a tone wheel with a reference gap (GM 58X, i.e. 60-2; Ford 36-1, 40-1 or 60-2) and gives the engine module speed and crank angle for injection and ignition. P0335 means it delivers no pulses although the engine demonstrably turns. GM proves the rotation via starter, camshaft pulses or airflow above 1.5 g/s and sets the code after at least 4 s of cranking or 0.3 s while running without a crank pulse (2 of 10 revolutions); petrol engines after two trips, the LML diesel in the first. Ford compares with the camshaft: more than one revolution without a crank signal, detected within 5 s. Without the signal the engine stalls or does not start; GM Global A engines (Saab 9-5 2010) keep running only with learned cam positions. A hot sensor that fails and recovers after cooling is typical.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 35

Possible causes

  • Crankshaft position sensor faulty (heat, age – typical hot-start failure) high
  • Connector or wiring corroded, chafed, oil-soaked or open high
  • 5 V reference shorted by another sensor on the same supply medium
  • Tone wheel damaged, loose or clogged with chips; air gap wrong after engine work medium
  • Engine module low

Symptoms

  • Engine cranks but does not start
  • Engine stalls while driving or at idle
  • Hot-start problem: starts again after cooling down
  • Tachometer drops out, check engine light on

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0335

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication