OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P032A

Knock/Combustion Vibration Sensor C Circuit

The knock sensor is a piezoelectric structure-borne sound sensor bolted to the engine block; the module evaluates its signal per cylinder and retards ignition when it detects knock. Sensor C is a third sensor on engines with three or four knock sensors (documented on the McLaren 12C V8 and in Ford's 2020–23 systems). With a fault the module retards ignition across the board as protection – noticeable loss of power and higher consumption. P032A means the sensor circuit is open or the signal stays below the noise threshold. GM feeds a 20 kHz test signal into the circuit and detects an open circuit when it does not cancel out, setting the code in the first trip; Ford sees any open or short as a knock signal that is too small compared with the speed- and load-dependent noise level (at least 1,500 rpm, 35 % load, warm engine).

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 2A

Possible causes

  • Wiring or connector chafed, broken or corroded (sensor often under the intake manifold) high
  • Knock sensor faulty (cracked piezo, moisture, heat damage) medium
  • Sensor loose or wrongly torqued medium
  • Engine software or diagnostic calibration low
  • Engine module input stage low

Symptoms

  • Check engine light on
  • Loss of power, sluggish response from ignition retard
  • Higher fuel consumption

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P032A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication