OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0322

Ignition/Distributor Engine Speed Input Circuit No Signal

P0322 means the speed and reference input of the ignition – today the crankshaft position sensor – delivers no signal although the engine is turning. Ford proves the rotation with the camshaft sensor: if it shows more than one engine revolution without a crank signal (from 500 rpm, detected within 5 s), Ford sets P0322 or, depending on the engine, P0335; with electronic throttle the throttle software adds P2106 and goes into limp mode. Without a crank signal there is no ignition or injection, so the engine stalls or does not start. Saab's Motronic 2.8.1 (900 V6) sets P0322 when the engine fails to start; its inductive sensor should measure 500–600 Ω and give 2–5 V AC while cranking. Systems without a camshaft-based check may store no code at all on a total failure.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 22

Possible causes

  • Crankshaft position sensor failed (often heat-related) high
  • Open or short in signal, ground or 5 V supply, corroded connector high
  • Sensor loose, air gap too large or tone wheel damaged medium
  • 5 V reference pulled down by another sensor on the same supply low
  • Engine module low

Symptoms

  • Engine cranks but does not start
  • Engine stalls while driving
  • Tachometer shows zero
  • Check engine light on, with electronic throttle limp mode (P2106)

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0322

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication