OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0320

Ignition/Distributor Engine Speed Input Circuit

P0320 originally covered the engine speed signal from the distributor or ignition module to the engine module (early OBD II); today Ford's engine module evaluates the crankshaft sensor directly and uses this code for it. Ford checks continuously from 200–500 rpm and sets it within 5 s when the number of teeth after the gap is wrong, the tooth time is implausible (below 30 or above 9,000 rpm) or the gap appears in the wrong place; fuel and spark are then cut briefly to resynchronise, and on electronic throttle P2106 limits power. Some Ford engines use P0339 instead. Typical causes are a faulty crankshaft sensor, interference in the wiring or a damaged tone wheel.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 20

Possible causes

  • Crankshaft or distributor speed sensor faulty or wrong air gap high
  • Wiring, connector or shielding disturbed (loose contact, interference from ignition or radios) high
  • Tone wheel damaged or dirty (missing tooth, metal chips) medium
  • Ignition module faulty on older vehicles medium
  • Engine module faulty low

Symptoms

  • Check engine light on
  • Engine dies or stumbles briefly
  • Starting problems, tachometer twitching
  • Reduced power on electronic throttle (Ford P2106)

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0320

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication