OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0315

Crankshaft Position System Variation Not Learned

Manufacturing tolerances of the crankshaft tone wheel distort the speed fluctuations misfire detection relies on, so the engine module learns a correction for each tooth or segment. P0315 means these values have not been learned or are invalid. GM checks that the learned tooth angles add up to 360° (deviation above 0.001° sets the code in the first trip) and learns them with a scan tool: brakes held, full throttle in park until fuel cut-off. Ford learns the profile during up to three overrun phases from 60 to 40 mph and sets P0315 when that fails. Until relearned, misfire detection is suspended – at GM above 1,000 rpm – and misfire readiness stays incomplete. The relearn is needed after replacing the engine, engine module, crankshaft, damper or crankshaft sensor.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 15

Possible causes

  • Relearn not performed after replacing sensor, crankshaft, damper, engine or engine module high
  • Learned values lost through voltage loss (battery disconnected) medium
  • Tone wheel damaged or shifted, crankshaft runout, dirt on the sensor medium
  • Interference in the crankshaft sensor circuit low
  • Engine module memory faulty low

Symptoms

  • Check engine light on (GM; Ford depending on application)
  • Driving usually unaffected
  • Misfire readiness not set – emissions test fails

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0315

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication