P0310
Cylinder 10 Misfire Detected
The engine module detects misfire from crankshaft speed: a cylinder that does not fire gives no acceleration impulse. At a catalyst-damaging rate (CARB: at least 5 % per 200 revolutions) the warning light flashes; at an emissions-relevant rate (at least 1 % per 1,000 revolutions – GM about 2–5 %, Ford 0.9–1.5 %) it comes on after two trips. Ford and GM may shut off a misfiring cylinder's injector to protect the catalyst. P0310 means more than 90 % of the detected misfires fall on cylinder 10. Usual causes are the ignition coil or spark plug of that cylinder, its injector, or low compression; a quick test is to swap coil or plug with a neighbouring cylinder and see whether the misfire moves. Cylinder 10 exists on ten-cylinder engines such as Ford's 6.8 litre V10; there an under-torqued crankshaft pulley bolt and engine software caused false misfire codes on all cylinders.
Possible causes
- Ignition coil of cylinder 10 faulty (coil, connector, ground) high
- Spark plug of cylinder 10 worn, sooted, cracked or wrongly gapped high
- Injector of cylinder 10 clogged or leaking, or its control medium
- Low compression on cylinder 10 (valve, rings, head gasket) or local false air low
- Water or oil in the plug well low
Symptoms
- Check engine light on, flashing at a catalyst-damaging rate
- Rough idle, jerking, vibration
- Loss of power, hesitation
- Smell of unburnt fuel, higher consumption
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0310
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.