P030D
Ignition B Control Signal Circuit/Open
Ignition B is one of the control signal lines from the engine module to an ignition module, ignition output stage or group of coils; which cylinders it serves is defined by the manufacturer, not by the code standard. The code concerns the logic-level control signal, not the coil's primary current (that has its own codes, P0351 ff and P2300 ff). P030D means the control line is open – the module sees a voltage with its driver off that indicates high resistance. No manufacturer using these codes was found; GM reports coil control faults as P0351 ff (open above 30 kΩ, first trip), so the description follows CARB and that analogy. The affected coils fire wrongly or not at all, causing misfire; many modules then shut off injection to those cylinders to protect the catalyst.
Possible causes
- Control line or connector pin open (corrosion, pushed-back pin) high
- Ignition module or coil with integrated driver of this group faulty medium
- Supply or ground of the ignition module faulty medium
- Driver stage in the engine module low
Symptoms
- Check engine light on
- Misfire, jerking, rough idle
- Loss of power, possibly cylinders shut off
- Additional misfire codes P0300 ff
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P030D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.