P02FD
Cold Start Fuel Injection Control Circuit High
Cold start fuel injection is an extra injection system for cold starts – for example on flex-fuel engines running on high ethanol blends, where a Hyundai patent describes a small auxiliary tank, a cold-start injector and a heater. CARB lists such heated fuel preparation systems among the monitored output components. P02FD means the control circuit reads high – typically the control wire shorted to a supply wire, or a bridged coil. The driver cannot switch the valve as commanded; cold starts become difficult. No manufacturer document using this code was found; unlike the older P0213/P0214, these codes separate the fault types.
Possible causes
- Control wire shorted to a supply wire (chafed or pinched) high
- Short in the cold-start injector or valve medium
- Moisture or corrosion in the connector low
- Driver stage in the engine module low
Symptoms
- Check engine light on
- Hard or no start in cold weather (especially with high ethanol)
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P02FD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.