P02FA
Diesel Intake Air Flow Position Sensor Minimum/Maximum Stop Performance
The diesel intake throttle learns the position sensor values of its end stops, as a Toyota patent describes for the closed stop at engine stop. P02FA means a learned end-stop value is implausible. Ford's 6.7 and 3.0 diesels check it once after each learning run and set the code when the learned minimum offset is outside ±10 (6.7) or ±6.7 (3.0) – Ford only evaluates the minimum stop. Typical causes are soot and oil deposits at the flap and stop, a worn or shifted sensor, mechanical damage or a replacement part that has not been learned. EGR control may be restricted.
Possible causes
- Soot and oil deposits at flap and stop (EGR, crankcase ventilation) high
- Position sensor in the throttle unit worn or shifted medium
- Flap or shaft bent, stop worn, gear worn medium
- Wrong or not learned replacement part low
- Engine software low
Symptoms
- Check engine light on
- Often no noticeable driving problems
- EGR control restricted, filter regeneration hindered
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P02FA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.