P02EA
Diesel Intake Air Flow A Position Sensor Circuit Intermittent/Erratic
The diesel intake air flow valve A is the throttle flap ahead of the intake manifold of a diesel engine: it creates the vacuum needed for high EGR rates, lowers airflow to heat the particulate filter and catalyst during regeneration and closes at switch-off against run-on shaking. A spring holds it open when unpowered; an electric motor positions it, with a position sensor reporting back. P02EA reports brief dropouts or jumps of the position signal – loose contacts, a wire breaking under movement or faulty digital sensor messages. No manufacturer using P02EA was found – GM reports such faults under its own codes, Ford does not use it – so the description follows CARB's input monitoring requirement. On a fault the valve is switched off and the spring opens it: driving is usually little affected, but EGR control is restricted and filter regeneration may be blocked.
Possible causes
- Loose contact at connector or pins high
- Wire breaking under movement medium
- Sensor with dropouts medium
- Electromagnetic interference low
Symptoms
- Check engine light (possibly intermittent)
- Valve occasionally switched off
- Irregular regeneration
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P02EA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.