OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P02E8

Diesel Intake Air Flow A Position Sensor Circuit Low

The diesel intake air flow valve A is the throttle flap ahead of the intake manifold of a diesel engine: it creates the vacuum needed for high EGR rates, lowers airflow to heat the particulate filter and catalyst during regeneration and closes at switch-off against run-on shaking. A spring holds it open when unpowered; an electric motor positions it, with a position sensor reporting back. P02E8 means the position signal is below its range – a signal wire shorted to ground or an open 5 V supply or signal wire. GM's LML sets it below 0.40 V for 5 s in the first trip, newer GM diesels with digital sensors below 1–5 % of 5 V after two trips; Ford's diesels below 0.08 V for 3 s. On a fault the valve is switched off and the spring opens it: driving is usually little affected, but EGR control is restricted and filter regeneration may be blocked.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / E8

Possible causes

  • Signal wire shorted to ground or 5 V supply open high
  • Sensor faulty medium
  • Connector corroded medium
  • 5 V reference loaded by another sensor low

Symptoms

  • Check engine light on
  • Often no noticeable change
  • Filter regeneration does not run, soot load rises

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P02E8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication