P02E7
Diesel Intake Air Flow A Position Sensor Circuit Range/Performance
The diesel intake air flow valve A is the throttle flap ahead of the intake manifold of a diesel engine: it creates the vacuum needed for high EGR rates, lowers airflow to heat the particulate filter and catalyst during regeneration and closes at switch-off against run-on shaking. A spring holds it open when unpowered; an electric motor positions it, with a position sensor reporting back. P02E7 is the position plausibility fault. GM's 6.6 litre LML implements it through position control: target and actual position differ by more than ±10 % for 10 s, two trips; newer GM diesels report the same as P02E1. It can mean a sensor reporting a wrong position as well as a stiff valve. On a fault the valve is switched off and the spring opens it: driving is usually little affected, but EGR control is restricted and filter regeneration may be blocked.
Possible causes
- Valve stiff or coked high
- Position sensor drifting medium
- Contact resistance in the sensor connector medium
- Gear play low
Symptoms
- Check engine light on
- Often no noticeable change
- Filter regeneration does not run, soot load rises
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P02E7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.