P02E6
Diesel Intake Air Flow A Position Sensor Circuit
The diesel intake air flow valve A is the throttle flap ahead of the intake manifold of a diesel engine: it creates the vacuum needed for high EGR rates, lowers airflow to heat the particulate filter and catalyst during regeneration and closes at switch-off against run-on shaking. A spring holds it open when unpowered; an electric motor positions it, with a position sensor reporting back. P02E6 is the general circuit fault of the position sensor, without telling low from high. GM and Ford use the split codes P02E8/P02E9 instead; no manufacturer using P02E6 was found, so the description follows CARB's input monitoring requirement and the documented siblings (GM 0.40/4.72 V, Ford 0.08/4.92 V). On a fault the valve is switched off and the spring opens it: driving is usually little affected, but EGR control is restricted and filter regeneration may be blocked.
Possible causes
- Sensor connector or wiring high
- Sensor in the valve unit faulty medium
- 5 V reference disturbed low
Symptoms
- Check engine light on
- Often no noticeable change
- Filter regeneration does not run, soot load rises
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P02E6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.