P02E3
Diesel Intake Air Flow A Control Circuit High
The diesel intake air flow valve A is the throttle flap ahead of the intake manifold of a diesel engine: it creates the vacuum needed for high EGR rates, lowers airflow to heat the particulate filter and catalyst during regeneration and closes at switch-off against run-on shaking. A spring holds it open when unpowered; an electric motor positions it, with a position sensor reporting back. P02E3 means the drive circuit is shorted to battery voltage: GM's LML detects 0.5 Ω or less for 3 s, two trips; Ford's diesels within 0.2 s. The driver switches off. On a fault the valve is switched off and the spring opens it: driving is usually little affected, but EGR control is restricted and filter regeneration may be blocked.
Possible causes
- Wire shorted to a supply wire in the harness high
- Corroded connector bridging pins medium
- Valve motor faulty internally medium
- Engine module low
Symptoms
- Check engine light on
- Often no noticeable change
- Filter regeneration does not run, soot load rises
- Shaking at switch-off
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P02E3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.