OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P02DE

Cylinder 10 Fuel Injector A Offset Learning At Min Limit

The engine module learns a small-quantity correction for each injector: on overrun it gives one injector a tiny test injection (GM about 1.5 mm³), measures the resulting crankshaft acceleration and corrects the injector's activation time per rail pressure step. P02DE means the learned correction for cylinder 10 has reached its lower limit at at least one pressure step: the injector needs much less activation time than nominal – it delivers too much at small quantities or opens early. Cylinder 10 exists only on ten-cylinder engines; no manufacturer using this code was found, so the description follows CARB and the documented codes for cylinders 1–8. It differs from P01DE (over advanced), which some systems derive from the same learning.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / DE

Possible causes

  • Injector of cylinder 10 leaking or over-delivering at small quantities high
  • Engine software (update available for some models) medium
  • Injector correction code not or wrongly programmed after replacement medium
  • Disturbed crankshaft signal (worn drive belt, tone wheel, dual-mass flywheel) low

Symptoms

  • Check engine light on
  • Often nothing noticeable; possibly rough idle or knocking
  • Possibly smoke or higher consumption

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P02DE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication