P02DC
Cylinder 9 Fuel Injector A Offset Learning At Min Limit
The engine module learns a small-quantity correction for each injector: on overrun it gives one injector a tiny test injection (GM about 1.5 mm³), measures the resulting crankshaft acceleration and corrects the injector's activation time per rail pressure step. P02DC means the learned correction for cylinder 9 has reached its lower limit at at least one pressure step: the injector needs much less activation time than nominal – it delivers too much at small quantities or opens early. Cylinder 9 exists only on ten-cylinder engines; no manufacturer using this code was found, so the description follows CARB and the documented codes for cylinders 1–8. It differs from P01DC (over advanced), which some systems derive from the same learning.
Possible causes
- Injector of cylinder 9 leaking or over-delivering at small quantities high
- Engine software (update available for some models) medium
- Injector correction code not or wrongly programmed after replacement medium
- Disturbed crankshaft signal (worn drive belt, tone wheel, dual-mass flywheel) low
Symptoms
- Check engine light on
- Often nothing noticeable; possibly rough idle or knocking
- Possibly smoke or higher consumption
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P02DC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.