P02D4
Cylinder 5 Fuel Injector A Offset Learning At Min Limit
The engine module learns a small-quantity correction for each injector: on overrun it gives one injector a tiny test injection (GM about 1.5 mm³), measures the resulting crankshaft acceleration and corrects the injector's activation time per rail pressure step. P02D4 means the learned correction for cylinder 5 has reached its lower limit at at least one pressure step: the injector needs much less activation time than nominal – it delivers too much at small quantities or opens early. GM diesels set it at limits of roughly ±66–182 µs after two trips. It is documented on GM's 6.6 litre L5P diesel and on Land Rover's 5.0 V8 petrol, where a software update is the first step. It differs from P01D4 (over advanced), which some systems derive from the same learning.
Possible causes
- Injector of cylinder 5 leaking or over-delivering at small quantities high
- Engine software (update available for some models) medium
- Injector correction code not or wrongly programmed after replacement medium
- Disturbed crankshaft signal (worn drive belt, tone wheel, dual-mass flywheel) low
Symptoms
- Check engine light on
- Often nothing noticeable; possibly rough idle or knocking
- Possibly smoke or higher consumption
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P02D4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.