OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P02D2

Cylinder 4 Fuel Injector A Offset Learning At Min Limit

The engine module learns a small-quantity correction for each injector: on overrun it gives one injector a tiny test injection (GM about 1.5 mm³), measures the resulting crankshaft acceleration and corrects the injector's activation time per rail pressure step. P02D2 means the learned correction for cylinder 4 has reached its lower limit at at least one pressure step: the injector needs much less activation time than nominal – it delivers too much at small quantities or opens early. GM diesels set it at limits of roughly ±66–182 µs after two trips. It is documented on GM's 6.6 litre L5P and 2.8 litre diesels – on the 2.8 a worn drive belt caused it to return after injector replacement – and on Land Rover's 5.0 V8 petrol, where a software update is the first step. It differs from P01D2 (over advanced), which some systems derive from the same learning.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / D2

Possible causes

  • Injector of cylinder 4 leaking or over-delivering at small quantities high
  • Engine software (update available for some models) medium
  • Injector correction code not or wrongly programmed after replacement medium
  • Disturbed crankshaft signal (worn drive belt, tone wheel, dual-mass flywheel) low

Symptoms

  • Check engine light on
  • Often nothing noticeable; possibly rough idle or knocking
  • Possibly smoke or higher consumption

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P02D2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication