OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P02D1

Cylinder 3 Fuel Injector A Offset Learning At Max Limit

The engine module learns a small-quantity correction for each injector: on overrun it gives one injector a tiny test injection (GM about 1.5 mm³), measures the resulting crankshaft acceleration and corrects the injector's activation time per rail pressure step. P02D1 means the learned correction for cylinder 3 has reached its upper limit at at least one pressure step: the injector needs much more activation time than nominal – it delivers too little or opens late, for example from coking. GM diesels set it at limits of roughly ±66–182 µs after two trips. Older GM calibrations (LML) use only this code of the pair, for both directions. It is documented on GM's 6.6 litre L5P and 2.8 litre diesels – on the 2.8 a worn drive belt caused it to return after injector replacement – and on Land Rover's 5.0 V8 petrol, where a software update is the first step. It differs from P01CF (over retarded), which some systems derive from the same learning.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / D1

Possible causes

  • Injector of cylinder 3 coked or worn (delivers too little) high
  • Engine software (update available for some models) medium
  • Injector correction code not or wrongly programmed after replacement medium
  • Disturbed crankshaft signal (worn drive belt, tone wheel, dual-mass flywheel) low
  • Low compression on this cylinder low

Symptoms

  • Check engine light on
  • Often nothing noticeable; possibly rough idle or knocking
  • Possibly smoke or loss of power

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P02D1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication