OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P02A8

Cylinder 4 - Injector Restricted

These codes belong to an individual-cylinder fuel correction: a diesel's cylinder balance control measures each cylinder's crankshaft acceleration and adjusts its injection quantity; on petrol engines a cylinder-selective mixture control does the same. CARB requires the system to report when such a correction has used up its range or one cylinder causes an imbalance. P02A8 means the module attributes the deviation of cylinder 4 to an injector delivering too little – deposits or a sticking nozzle needle. GM's 2.8 litre Duramax lists it as a stuck-injector fault in its cylinder balance system, which then switches the balance control off. GM and Ford use other codes for this (P0263 ff, P219A ff); no manufacturer document describing this code with thresholds was found, so the description follows CARB and published patents.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / A8

Possible causes

  • Deposits or coking at the nozzle of cylinder 4 high
  • Nozzle needle sticking medium
  • Contaminated fuel or water medium
  • Injector circuit high-resistance medium
  • Compression loss mimicking low output low

Symptoms

  • Check engine light on
  • Rough idle, vibration
  • Lack of power, higher consumption or smoke

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P02A8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication