OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0289

Cylinder 10 Injector A Circuit High

P0289 means the control wire of the cylinder 10 injector is shorted to voltage. GM detects this with the driver on: on direct injection by 25 A or more through the driver, on port injection and Duramax diesels by 0.5 Ω or less to the supply. On Ford's 6.7 diesel it means the injector's high side is shorted to its low side, reported within 0.3 s. Most systems switch the warning light on in the first trip (some GM port-injection engines and Saab's 2.0 turbo after two) and shut the affected injector off, so the cylinder misfires. Ford petrol engines report all injector circuit faults as P0201 ff instead. Cylinder 10 exists only on ten-cylinder engines; no manufacturer document using this code was found – Ford's V10 uses P0201–P0210 and GM has no V10 – so the description follows CARB and the codes for cylinders 1–8.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number2 / 89

Possible causes

  • Control wire of the cylinder 10 injector touching battery voltage or another supply wire high
  • Injector coil shorted internally (too low resistance, overcurrent) medium
  • Short between supply and control wire in harness or connector medium
  • Driver stage in the engine module faulty low

Symptoms

  • Check engine light on
  • Misfire and rough running, misfire code P0310
  • Loss of power, rough idle
  • Injector shut off, limp mode possible on diesels

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0289

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication